[MUSIC PLAYING] Insert the battery with the magnet tip of the tool. Make sure that the battery is placed completely in the battery compartment with the plus facing up. Switch the device on by closing the battery door completely. To switch hearing aid off, open the battery door. Open the battery door to store the hearing aid, or, if you want to change battery. Use the tool to removable old battery. It might be helpful to do this over the table to not lose the battery. It is easier to insert a custom hearing aid if you pull your ear back. Insert hearing aid into the ear canal. Flat side should always face front. Red for right, and blue for left ear. Insert the microphone inside the top part of your ear. Microphone should easily fit. To change environmental programs, press and release the push button of the device. Program change is indicated by a beep sound. To activate TV streamer program, press and hold the push button for two seconds. A long melody indicates an active streaming program. To increase the volume, turn the volume control wheel towards the front of your head. To decrease the volume, turn the volume control wheel towards the back of your head. To remove the hearing aid, gently pull the microphone and tube from your ear. Hold the microphone tube and gently pull out the hearing aid. Use a twisting move towards front for easier removal. Clean your hearing aid using the clean brushing and dry cloth included in your hearing aid kit. It is important to keep your hearing aid clean from ear wax and dust. Use the other tip of the tool to remove earwax from the openings. After brushing, clean your hearing aid with the dry cloth. For storing, it is recommended to leave battery door wide open for proper ventilation. Use metal part of the tool to screw into the old filter and pull it out. Insert used filter into the filter pack. Open new filter. Use plastic tip to mount new filter in the device. Push the tool until filter clicks in. Push the tool with the new filter into the receiver opening of the hearing aid. When the filter clicks, gently pull out the tool, make sure that the filter is mounted firmly.