Return to Site
Warehouse Locations Renew Membership Join Costco Customer Service
Click here for warehouse coupons
Order by Item Number Order Status My Account Sign In or Register

Video: Kanto FMX2 Installation Video

Video Gallery
Close Top

Kanto FMX2 Installation Video

Length: 3:28 Added: Oct-9 Views: 283

Video featuring products available on Costco.com.

50%
EN ES FR

Video featuring products available on Costco.com.

[MUSIC PLAYING] This video will demonstrate the insulation of an FMX2 full motioned, flat panel TV mount by Kanto AV systems. With the heavy-duty wishbone arms, the FMX2 will support TVs up to 70 inches and support up to 130 pounds. Included in the box are all the components you need to install this mount. In addition to these, you'll need some tools. Please refer to the manual to see exactly what tools you'll need. If you have any questions about installation or parts, please contact us at 1-888-848-2643. Place your TV temporarily on your TV stand if you have one, and attach the bracket arms. Do not lay your TV face down on the screen to do this. All TVs have designated pre-threaded holes for this purpose. This is more commonly known as the VESA hole pattern. Using the screws provided, attach the bracket arms to the back of the TV at the desired height. Snug up the screws, but do not overtighten them. Before you mount the TV, make sure the safety bolt is unscrewed so it is flush. Using a stud finder, locate the center of the first stud. Then locate the second stud. After marking the centers of each stud, make sure they are level. Drill pilot holes into each stud. Thread the supply washers onto each of the four lag bolts. Use a lag bolt to attach to wall mount to the first stud without fully tightening it. Rotate the mount to meet the second hole. Install the second lag bolt. Before you tighten the lag bolts, check that the mount is level. Tighten the lag bolts until the wall plate is snug against the wall. The wall plate can be used as a template. Verify the center of the stud again. Drill the bottom two pilot holes. Insert and tighten the black bolts until it's snug. Lift your TV, and hook the bracket arms onto the TV plate. If you have a heavy TV, make sure to use two people to lift it into place. Once you have your TV in position, secure it using the safety bolt. Our mount offers the functionality to fine tune the horizontal adjustment to perfectly fit your needs. To do this, loosen the three bolts on the back of the TV plate. Adjust the TV and tighten the bolts. The FMX2 can tilt plus or minus 15 degrees. Tilt the TV into the desired position, and using the levers on the tilt head, secure your TV. Fully extended, the FMX2 gives you a range of over 20 inches from the wall. Fully compressed is 3 and 1/2 inches from the wall. If desired, thread your cables through the cable routing system to keep your cables clutter free. Thank you for buying one of our mounts. To learn more about our mounts or our company, please visit kantoav.com. [MUSIC PLAYING]